• Epoxy bodied electrode, featuring Ag/AgCl, Gel filled, Double Junction reference with Additional Salt Rings for a longer life electrode.
• Designed with a Porous Teflon double junction which allows for use in difficult sticky samples where blockage of a liquid junction is common.
• Sensor is supplied with 1 metre cable and BNC connector.

The post O14/DJ/TEF/1M/BNC Epoxy Combination ORP Electrode appeared first on Sentek Limited.

• Designed for general purpose water-based conductivity measurements.
• Particularly good in dirty high conductivity samples and is easily cleaned.
• Compatible with Thermo Orion, Mettler Toledo, Eutech and WTW instruments. Please specify make and model when enquiring.
• Perfect for instrument manufacturers to offer as accessories for meters.

The post K25/G Glass Bodied K=0.8 Laboratory Conductivity Electrode appeared first on Sentek Limited.

• pH electrode with rod shaped membrane for extra strength and durability.
• Versatile refillable pH probe, featuring an Annular Ceramic junction.
• Supplied with 1 meter cable and BNC connector.

The post P11 Rod Glass Combination pH Electrode appeared first on Sentek Limited.

Epoxy bodied, 4-pole conductivity electrode with carbon plates, K=0.55 cell constant and optional ATC.

When ordering conductivity cells please specify make and model of conductivity meter.

The post K25 General Purpose K=0.55 Laboratory Conductivity Electrode appeared first on Sentek Limited.

The post R4 AgCl Epoxy Teflon Junction Reference Electrode appeared first on Sentek Limited.

Epoxy bodied conductivity electrode with carbon plates, K=1 cell constant and optional ATC.

When ordering conductivity cells please specify make and model of conductivity meter.

The post K20 Epoxy Bodied K=1 Laboratory Conductivity Electrode appeared first on Sentek Limited.

• Refillable single junction pH titrator electrode.
• New improved formulation of non-aqueous fill solution but can be used with traditional LiCl based solutions as well.
• Designed for use with modern autotitrators.
• NS14/15 cone type for use in laboratory glassware.
• Easy to store, clean and maintain.
• Renewable junction design prevents junction clogging.
• Sensor is supplied with an S7 connector allowing use of a detachable cable for convenience and compatibility with almost any meter.

The post P21-NS14/15-S7 pH Difficult Samples Titrator Electrode appeared first on Sentek Limited.

• pH sensor designed for non-aqueous samples. Renewable junction design prevents junction clogging.
• Pseudo double junction where the reference is protected in a KCl/AgCl gel filled coil allowing an array of non-aqueous fill solution to be used within the same sensor.
• Allows aqueous and non-aqueous samples to be measured with same sensor, simply by changing the fill solution.
• New improved formulation of non-aqueous fill solution but can be used with traditional LiCl based solutions as well.

The post P21 Sleeve Junction Colloids/Low Conductivity pH Electrode appeared first on Sentek Limited.

• Porous Teflon junction designed to be easy to clean and resist against blockages.
• Robust epoxy body designed for tough applications.
• Versatile refillable probe allowing an extended life span.
• A flat surface pH glass membrane is perfect for surface measurements or samples that may damage glass membranes.
• Resistant to breakage due to very little glass exposed.

The post P17 Flat Head Combination pH Electrode appeared first on Sentek Limited.

• pH electrode perfect for pH measurements in the laboratory and where higher accuracy measurements are required of samples.

The post P11 Glass Combination pH Electrode appeared first on Sentek Limited.